|
Post Reply
Matt 2010-01-29 00:14
I'm running a media center in a secondary monitor at times and I want to be able to bind a hotkey with my remote to disable the primary monitor to save energy/prevent glare, etc.
My point is I'd like to request a new action/hotkey that would toggle disabling and enabling the primary monitor. This new action would complement the already existing 'disable or enable secondary monitors' action.
Cheers for reading,
Matt
|
Christian Studer 2010-01-29 09:07
This won't work, the primary monitor can't be disabled, but you could set the secondary as primary, then disable the original primary monitor.
You could do this with a display profile, UltraMon menu > Display Profiles, then use an 'Apply display profile' hotkey to apply the profile.
Christian Studer - www.realtimesoft.com
|
Matt 2010-01-29 22:30
Thanks for your reply.
In the end I created two profiles. The first being my original setup with both monitors enabled. Then the second with the original primary now switched to secondary and then subsequently disabled. I then call these profiles using my remote software and use a parameter to remember which was pressed last so that the same button can be used as a toggle.
Thanks for the inspiration - I hadn't thought of doing it like that!
Cheers,
Matt
|
Post Reply
|
