|
Post Reply
EC82 2011-02-19 13:35
Just downloaded UltraMon and I am attempting to setup 3 monitors. In the display setting I can see all 3, one is dotted lines though. I can activate it, and adjust its setting, but my screens are not displaying it. Instead my laptop and my main monitor seem to be linked and display the same desktop.
How can I properly set this up? Every time I apply changes, it revers back to the dotted line for monitor 1 (laptop) and just clones monitor 3 (large display) onto it.
|
Christian Studer 2011-02-20 06:19
Sounds like you're using clone mode, try switching the laptop to extended desktop mode via the software for the video chipset, usually you can do this via an item under Start Menu > Control Panel.
Christian Studer - www.realtimesoft.com
|
EC82 2011-02-20 06:38
Thank you so much! With a little adjusting I was able to get everything in working order!
|
Post Reply
|
