|
Post Reply
P4rD0nM3 2011-11-02 12:04
Everytime I restart Vista, my second monitor doesn't load. Is there a way to force Ultramon to enable my secondary monitor right after windows loads?
|
P4rD0nM3 2011-11-02 12:11
2 monitors
Current desktop: 4096x1152 (0,0 - 4096,1152)
Monitor 1 - SyncMaster 2343(BWPlus/BWXPlus) (Digital) (primary):
Settings: 2048x1152, 32-bit color, 60 Hz refresh rate
Coordinates: 0,0 - 2048,1152. Workspace: 0,0 - 2048,1122
Video card: ATI Radeon HD 4870 X2
Device: \\.\DISPLAY1\Monitor0
Monitor 2 - SyncMaster 2343(BWPlus/BWXPlus) (Digital):
Settings: 2048x1152, 32-bit color, 60 Hz refresh rate
Coordinates: 2048,0 - 4096,1152. Workspace: 2048,0 - 4096,1122
Video card: ATI Radeon HD 4870 X2
Device: \\.\DISPLAY2\Monitor0
|
P4rD0nM3 2011-11-02 12:12
Here's a more detailed explanation.
1. Restart PC.
2. First monitor loads.
3. Second monitor loads...then goes into standby mode.
4. I re-enable the 2nd monitor through either Windows' display menu or through UltraMon.
|
Christian Studer 2011-11-03 08:12
You could do this with a display profile, to set this up select Display Profiles > New Display Profile from the UltraMon menu, then configure settings as desired and check 'apply this display profile when logging in' on the last page of the wizard.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
