|
Post Reply
allen 2011-11-05 00:11
System info is below. The move to other monitor context item is greyed out on all programs and buttons are missing. I reinstalled 3.1.0 with no change and they are checked in options.
Recently installed win 7 sp 1 it failed after that. Not sure how long after though.
Any one else have problems with sp1?
2 monitors
Current desktop: 3200x1080 (0,0 - 3200,1080)
Monitor 1 - DELL S2409W (primary):
Settings: 1920x1080, 32-bit color, 60 Hz refresh rate
Coordinates: 0,0 - 1920,1080. Workspace: 0,0 - 1920,1080
Video card: ATI Radeon HD 4800 Series
Device: \\.\DISPLAY1\Monitor0
Monitor 2 - Generic Non-PnP Monitor:
Settings: 1280x1024, 32-bit color, 85 Hz refresh rate
Coordinates: 1920,0 - 3200,1024. Workspace: 1920,0 - 3200,1024
Video card: ATI Radeon HD 4800 Series
Device: \\.\DISPLAY2\Monitor0
|
Christian Studer 2011-11-05 05:23
SP1 should be no problem, you would get this behavior if UltraMon thinks you only have one monitor enabled, but that doesn't seem to be the case.
Does restarting UltraMon fix the problem?
Christian Studer - www.realtimesoft.com
|
allen 2011-11-05 06:51
That worked which seems odd as I rebooted after it was installed.
Thanks
|
Christian Studer 2011-11-05 07:43
If you get this again when you restart the system the next time, it could be a timing issue of some sort, in that case it would be possible to delay UltraMon startup as a workaround.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
