Post Reply

Forums -> UltraMon™ -> second screensaver does not launch after reset
dani   2013-02-05 13:19
Hi,

I'm using win7. I set my primary mon with 1 screensaver, and my secondary mon with another. It runs fine, but after a reset, the secondary mon screensaver doesnt run. Just the primary mon screensaver runs, and the secondary mon runs a blank screen.
When I went back into the screensaver "Configure...", the settings are still there, but just doesnt work. Until I manually press "Launch", the whole thing works find again.
So after every reset, I have to manually press launch to get it going again.. Good thing I didn't buy it yet

Dani
Christian Studer   2013-02-06 08:14
When this happens, is UltraMon still set as your screen saver under Control Panel > Personalization > Screen Saver?

Christian Studer - www.realtimesoft.com
Dani   2013-02-06 12:00
Yes, it is set to ultramon saver in the personalize section. But ive noticed that even without resetting the comp, the ultramon saver will run 1 side after some time. I believe its caused by clock-7 saver is for single mon, and the other saver (windows default savers) are capable for dual mon.. Maybe its crashing it. Let me do some test and i will get back to you. I will set the windows default saver on the primary mon and see what happens

Dani
Dani   2013-02-14 12:10
Solved! Just needed to check the "preview mode" for both screensaver. Everything works perfectly now. Thanks

Dani
Forums -> UltraMon™ -> second screensaver does not launch after reset

Post Reply