|
Post Reply
Greg Pin 2002-07-19 08:05
Hi everyone,
I using two NVIDIA video cards, AGP and PCI.
And under the Nview settings of the NVIDIA I have the option to apply color correction to my second monitor to have the same color temperature on both screens.
But even by checking the radio box "Automaticaly apply these settings at startup", my color setup are reset to default. Everytime I reboot my computer I have to go in my display properties and set it to my profile.
Any solutions ? Is it ultramon, nvidia, unproper setup ??
PS : This is only affected when I reboot, not when I enable or disable ultramon.
Thanks in advance.
Greg.
_________________________________________________
2 monitors
Current desktop: 3200x1200 (0,0 - 3200,1200)
Monitor 1 - SONY CPD-E400/E400E (primary):
Settings: 1600x1200, 32-bit color, 60 Hz refresh rate
Coordinates: 0,0 - 1600,1200. Workspace: 0,0 - 1600,1172
Video card: NVIDIA Quadro2 Pro
Device: \\.\DISPLAY1\Monitor0
Monitor 2 - SONY CPD-E400/E400E:
Settings: 1600x1200, 32-bit color, 70 Hz refresh rate
Coordinates: 1600,0 - 3200,1200. Workspace: 1600,0 - 3200,1172
Video card: NVIDIA GeForce2 MX/MX 400
Device: \\.\DISPLAY2\Monitor0
__________________________________________________
|
Christian Studer 2002-07-19 09:36
Works fine on my system, with a secondary GeForce2 MX and the 29.42 drivers (on Windows XP).
Most likely it's a driver issue, let me know if you still have the problem with the latest Nvidia drivers.
Christian Studer - www.realtimesoft.com
|
Deam 2002-08-08 03:27
Do you Save it in colour corrections tab?
Ie. Beside the checkbox, there is a save button.
I believe you have to save the changes, then apply them...
|
Post Reply
|
