|
Post Reply
artaxerxes 2002-09-19 21:41
Hello,
Been using your utility on and off for most of this year - and finally purchased it last month.
I was using a S3 Savage 2000 and two ATi Mach64s to drive 3 14" monitors (luxury!).
I just upgraded to a Radeon 8500LE. Apart from that the setup has not changed.
The Radeon has native support for 2 monitors - but one of them would need ot be DVI which i don't have.
However the Radeon 8500LE believes there is a second monitor there. So when I flick back to 'all-screens mode' from 'single-monitor mode' a phantom monitor is enabled. Generally in between two of the other monitors at random.
Is there a way of selecting which monitors are re-enabled with the clicking of the systray icon rather than the default all?
Thanks in advance.
artaxerxes
|
Christian Studer 2002-09-19 23:18
You can tell UltraMon to ignore this monitor, this way it won't be enabled/disabled, and will not appear anywhere in the UltraMon user interface.
To configure ignored monitors, go to Options > Ignored Monitors.
Christian Studer - www.realtimesoft.com
|
artaxerxes 2002-09-19 23:21
Thanks - obvious.
But hey it can be done and i don't mind demonstrating my ignorance if I can then get to the functionality.
Thanks again.
artaxerxes
|
artaxerxes 2002-09-20 05:01
Okay - at home now and trying the tweak.
I disabled it manually and can see no disable monitor message that relates to single monitor choice? Do i need an update?
4 monitors, 1 disabled
Current desktop: 2400x600 (-800,0 - 1600,600)
Monitor 1 - Packard Bell 1412SME (primary):
Settings: 800x600, 32-bit color, default refresh rate
Coordinates: 0,0 - 800,600. Workspace: 0,0 - 800,600
Video card: RADEON 8500 Series
Device: \\.\Display1\Unit0\Monitor1
Monitor 2 - (disabled):
Settings: 640x480, 8-bit color, default refresh rate
Coordinates: 320,-240 - 960,240
Video card: RADEON 8500 Series
Device: \\.\Display1\Unit1
Monitor 3 - HP D1194A SVGA 14-inch Display:
Settings: 800x600, 32-bit color, default refresh rate
Coordinates: 800,0 - 1600,600. Workspace: 800,0 - 1521,600
Video card: ATI Rage II+ PCI (ati_m64)
Device: \\.\Display2\Monitor1
Monitor 4 - Daewoo CMC-1423B1:
Settings: 800x600, 32-bit color, default refresh rate
Coordinates: -800,0 - 0,600. Workspace: -800,0 - 0,600
Video card: ATI Rage II+ PCI (ati_m64)
Device: \\.\Display3\Monitor1
Thanks again
|
Christian Studer 2002-09-20 05:51
Did you configure the ignored monitors setting under Options > Ignored Monitors?
If you don't have this tab, you'll need to install a newer version. RC2 will be released tomorrow, I would recommend waiting for this release.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
