|
Post Reply
Nev 2002-11-07 11:00
After installing the final release code V2.0 I have been unable to run an OpenGL screen saver on my secondary monitor. The configure screen displays the screen savers running on both monitors, but preview only runs the screen saver on the primary monitor. The standard openGL flower box will run accross both monitors, but I have been unable to run two seperate SCRs since the final release was installed.
I did completed remove, reboot, then install. I am running XP Pro.
Nev
|
Christian Studer 2002-11-07 12:22
Make sure you have checked preview mode for the screen saver on the primary monitor, otherwise it will run on all monitors. FlowerBox and Flying Objects worked fine on my system.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
