|
Post Reply
Tony 2019-08-09 07:46
I'm trying to layout a 4 monitor system as (1 is primary):
3
412
When I set it, it appears to configure properly but when I click OK (versus revert or revert later) it changes to (2 has become primary)
4132
I then have to lay it out again as:
XPXT for it to stick. It worked once before but then something changed and it reverted on it's own.
I don't know what version of ultamon I'm running but I'm sure it's old. I'm running on Windows 7. Any thoughts on how I might be able to get the layout to stick and for it NOT to change the primary monitor?
tony
|
Christian Studer 2019-08-10 09:59
Could be due to the version of UltraMon you're using, to check which version you have installed right-click the UltraMon icon in the system tray and select About from the menu, the version is shown at the top.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
