|
Post Reply
Avi 2006-06-28 23:27
Message posted to Microsoft, which might be relevant to Ultramon:
View Visio's rendering problem: I have a page with shapes that extend outside the page. The page has a vertical scroll bar to the left, which is OK. After srolling to the right, however,a "bar" at the right edge of the screen where the page appears to be overlayed by a vertical bar about the width of the scroll bar. It's probably hard to see this in the sent picture, but this bar replicates a vertical strip of the picture a little left to the center, identifed by the "re" of the word "create". This behaviour continues even after I've closed and reopened Visio. The stip disappears when I scroll to the left.
It MIGHT be relevant that I'm using a dual monitor setup running Matrox and the Ultramon utility software version 2.5.22 by RealtimeSoft (www.ultramon.com).
|
Christian Studer 2006-06-29 11:11
I haven't been able to reproduce this issue, horizontally scrolling a page with shapes partially outside the page caused no drawing errors.
Testing was done with UltraMon 2.6 and Vista 2007 Beta 2 on Windows XP SP2.
I could try to reproduce the issue with the specific Visio file you're using, if you would like to do this please send the file to support@realtimesoft.com.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
