|
Post Reply
keith 2007-10-03 16:14
I have a pci express 16 card a nvidia GeForce 7300 LE that I had two crt monitors working on.
Then I added a Raeon 7000 series card that goes in a PCI slot so I could have a third crt monitor.
When I put in the drivers it took off the nvidia display manager and installed the ATI catalyst control center. No Big deal but now the other two monitors dont work and they wont enable when I right click on the display and try to enable them.
The nvidia card shows up in device manager and says it is working properly.
I am at a loss now. What can I try next?
Spire SilverFin III All fan grilles cut out 120mm Intake - Exhaust & Blow hole
Asus A8N-E Socket 939/nForce4 Ultra- Syba CL-CNL-CHPMG2 Northbridge Chipset Cooler
AMD Opteron 170 Dual Core Processor LCB9E Topless ARCTIC COOLING Freezer 64 Pro
CPU@2700 MHZ - 270x10 - 1.31 Vcore - Ht link 810 - Memory 180- Still OCing
Seagate Barracuda 7200.9 120GB 7200 RPM 8MB Cache SATA 3.0Gb/s
OCZ Platinum 2GB (2 x 1GB) 184-Pin DDR SDRAM DDR 400 Dual Channel Kit
Enhance ENP-5240G 400W v2.2 Dual-Core 24/20-pin Power Supply
ASUS EN7300LE/HTD/128M GeForce 7300LE 64-bit GDDR2 Video Card
|
David DeRolph 2007-10-11 03:15
I don't know how to resolve your problem but I think it's unfortunate that you did not get another nVidia card. I believe using two nVidia cards or two ATI cards is less likely to cause such problems. I have an AGP card and a PCI card installed to run two monitors. Since both have nVidia graphics chips, they use the same driver. No chance of conflict in such a setup.
|
Post Reply
|
