|
Post Reply
Edwin 2008-01-08 04:14
I'm running a 16 monitor system and am having a few issues with ultramon. The first thing is that whenever i hit identify monitors and the numbers show up fine....then I arrange them in the view window the way I want and hit apply it seems everything is working but when i hit identify again everything is back the way it was before.. Also there are two monitors that i cannot enable,I check the enable box and hit apply and it just goes back to disabled. It is like ultramon isn't saving my settings. Any help would be appreciated......Thanks
|
Christian Studer 2008-01-08 13:54
Make sure you don't select Yes when asked if you want to restore the original settings (this is different from the confirmation dialog shown by Display Properties).
Enabling a monitor might fail if the monitor isn't connected properly, or if there is another problem with the monitor itself or the video card driver. I would also recommend checking Device Manager for any issues with the video cards or monitors.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
