Post Reply
Peter Inglis 2001-11-27 13:38
Hi,
I've been successfully running an AGP Geforce 2MX and 2 S3 PCI cards. I'm in the process (?) of trying to get two Prophet Kyro 4000XT PCI cards to run instead of the S3.
At the moment I have the Geforce AGP working as the main card (... again.... finally!!!!) and have one Kyro PCI in. On boot up the Kyro shows on the screen - then reappears with the "If you can see this.." message, but when the Win 98SE 2nd edn desktop shows on Monitor 1, monitor 2 goes back to a blinking cursor.
If I try yoo hard too enable it it crashes / hangs the whole system.
Any ideas?
TIA
Peter "MiGMan" Inglis migman@migman.com Flight Sim Museum www.migman.com
|
Christian Studer 2001-12-05 10:58
Did you check Device Manager > Display adapters for any error messages? It's most likely a driver issue, but could also be something else.
Christian Studer - www.realtimesoft.com
|
Marten 2002-01-10 14:07
Yes, with GF2MX plus 4000XT, I have found (under win2k) that I can only get both to work if my system boots off the 4000XT (pci) and then switches primary displays later in the OS.
|
Post Reply
|