|
Post Reply
John 2009-03-04 05:54
Hi
I have just purchased Ultramon, and unless I am doing something wrong, it dosent seem to do what I expected, or need.
Basically I wish to use two monitors to veiw my application. I need both monitors to show the application full screen, but one monitor at 1280 resolution and the second monitor at 1024 resolution.
The best I seem to be able to achieve is the first monitor at 1280 and the second showing the same image but only the middle 1024 picels of the application not the full picture.
John
|
Christian Studer 2009-03-04 09:33
This should work fine with UltraMon mirroring, you can start it via UltraMon menu > Mirroring.
Christian Studer - www.realtimesoft.com
|
John 2009-03-04 10:18
Hi
Thanks for the reply , however it is Mirrowing I am trying to use, I have the first monitor set at 1280 and the second at 1024, however in reality both momitors are showing the application at 1280.
I have checked in display settings and these read o.k. at 1024 and 1280.
I have also checked the monitor menus which also read 1024 and 1280.
However the images on the monitors are identical.
John
|
Christian Studer 2009-03-06 02:29
By default UltraMon ensures that the whole source image is visible on the mirror target monitor, either by shrinking or stretching the mirror image.
If you don't want this, you'll need to have version 3.0.3 or later installed, and under options, make sure both the stretch and shrink mirror image options are unchecked.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
