Jon 2009-03-24 18:32
Hi
Ultramon is a fantastic app but there is one pesky application that refuses to work with it properly
I have an application called Maximus Arcade which when started runs fullscreen (as it is a fullscreen app) no matter whether i try a shortcut or script based off of the samples on this site it always loads onto my primary display
I have 4 monitors set up my television being #4 and I have tried all i can think of to get it to load up and move to #4 but to no avail
Do you have suggestions as to what I can do and if so, how?
Any help would be so very much appreciated I've been going batty trying to figure out a solution
Thanks a lot!
- Jon
|
Christian Studer 2009-03-25 09:18
Can you move it to the other monitor with a Move Window hotkey? You can configure hotkeys under UltraMon Options > Hotkeys.
Christian Studer - www.realtimesoft.com
|
Jon 2009-03-25 09:34
Thank you for the response!
I was able to move it using a hotkey!
Is there any way to move it through scripting at startup so it's automated? Perhaps to set a primary display before it loads then after it unloads reset it back or something?
I wonder why the hotkey works but scripting not..
Thanks so much for your help!
|
Jon 2009-03-25 09:41
Just as a followup although i can move the app it still loads things on primary, so i guess I have no choice but to switch primary on startup or something
thanks a lot!
- Jon
|
Christian Studer 2009-03-26 10:19
To change the primary monitor before launching the application, right-click the application's shortcut, select Properties, then select the UltraMon - Display tab and configure settings as desired.
Did you already try moving the application by setting a position on the UltraMon - Window tab for the application's shortcut?
Christian Studer - www.realtimesoft.com
|
