|
Post Reply
John Schutzman 2007-04-11 07:18
Trying to Mirror Monitor 1 on Monitor 2 using a command line switch.
What would be the command line I'd use to do this???
According to UltraMon Help file...
<![CDATA[using UMMirrorClient.exe /start]]>
that only brings up the Mirroring dialog box where I have to manually tell monitor 2 to mirror 1
The Help file contains this rather cryptic explanation:
<![CDATA["monitor: one-based number of the monitor you want to mirror"]]>
What is "one-based number" ????
John Schutzman
IS Technician
|
Christian Studer 2007-04-11 09:38
There is no direct way to do this, what you could do is configure mirroring settings via UltraMon menu > Mirroring > Settings, then launch mirroring by running UMMirrorClient.exe with the /start switch.
Mirroring only a single window is not supported, but you could do this with the older version of mirroring, MirrorMon.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
