|
Post Reply
morkboy_wonder 2007-06-09 07:16
Wasn't sure which forum I should put this question in.
I recently downloaded the trial copy of ultramon and tried to set up a rig where my 8800GTX would run two monitors for gaming/work and have a third display, a TV, running off my 7900GT. My aim was to have a setup where I wouldn't keep having to change my two screen setup in the control panel every time I wanted to watch movies
UltraMon seems to have worked well and I now see three screens on the desktop display. My problem is that when I try to open the nvidia control panel to adjust my 8800GTX the control panel is set to the 7900GT. I have tried uninstalling/reinstalling but get the same results. Am using Rivatuner now to tweak my 8800GTX but I would prefer to access it by the normal route. Has anyone had a similar problem?
Thanks in advance
|
Christian Studer 2007-06-09 09:29
That's most likely an issue with the Nvidia software, to verify this check if you still have the same problem without UltraMon installed.
BTW, with some driver versions you could select the card on the left of the control panel if multiple Nvidia cards were installed.
Christian Studer - www.realtimesoft.com
|
Post Reply
|
